Using a hammer, tap the head of the Kwik Bolt 3 back into the hole. With a screwdriver, turn the post nut clockwise 3 full turns.ĥ. Thread post nut completely onto the Kwik Bolt 3 anchor body and tap anchor with a hammer through the fixture and into the hole.Ĥ. Drill a hole in concrete using a hammer drill.ģ. Installation Instructions for the Countersink Kwik Bolt 3ġ. Using a wrench, tighten the nut to the installation torque value recommended. With a hammer, strike the top of the Kwik Bolt 3 until a minimum of 6 threads are below the surface of the fixture.Ĥ. When the diameter of the hole in the fixture is large enough for the carbide bit to fit through, the fixture can be used as a template.ģ. The hole depth must be a minimum of one anchor diameter deeper than the anchor will be embedded into the concrete. The Kwik Bolt 3 does not need the bottom of the hole to be set. The hole diameter to be drilled is the same as the diameter of the anchor being installed. A hammer drill must be used to drill a hole into the concrete. Installation Instructions for the Kwik Bolt 3 (Stud Version)ġ. It is important when installing the Kwik Bolt 3 to use a hammer drill and a carbide bit for drilling the hole in the concrete base material. The Hilti Kwik Bolt does not need the bottom of the hole to be set because one end is threaded and each diameter and length is packaged with the correct size and number of nuts and washers. The Kwik Bolt 3 is available in four different versions: the standard stud version that uses a nut & washer, flat countersunk, rod coupling, and ceiling.

The Kwik Bolt 3 is manufactured in three different steel types: 304 stainless steel, 316 stainless steel, and standard, zinc plated carbon steel.

The Kwik Bolt 3 should not be used in brick or block base material because it is designed for use in solid concrete only. The Kwik Bolt 3 is the most current version of the Kwik Bolt that is sold by Hilti.

Hilti anchors in cmu block